Motec ADR Uživatelský manuál stáhnout pdf (Strana 5)

ADR Functionality User Manual Configuration

Configuration

The ADR Manager application is used to configure the ADR, upgrade the firmware, and carry out event management

activities such as downloading and erasing data.

Connection to the ADR

ADR Manager connects to a powered ADR unit over the CAN bus. The connection can be made through a MoTeC

UTC (USB to CAN), or through a MoTeC Ethernet connected logger or ECU wired on the same CAN bus as an ADR.

MoTeC Ethernet devices include ACL, ADL3, CDL3, SDL3, C185, C125 and M1 ECUs.

Note: To allow a connection through a MoTeC Ethernet device, the UTC connection setting accessed

via the Tools > Options menu must be disabled.

If the ADR being connected has a password set, the password prompt is displayed. The correct password must be

entered before any other operations can be performed.

When an ADR is connected, a summary of the logged events is listed as shown in figure 2. The connection status and

ADR serial number are shown in the ADR Manager Status bar.

Serial

number

Connection

status

Figure 2 – Example ADR Manager window on connection to an ADR

MoTeC — Published: 11 February 2014 Page 4

1 2 3 4 5 6 7 8 9 10 ... 24 25

Žádné komentáře

Motec ADR Uživatelský manuál Strana 5